Page 1 of 1

CAPsMAN issue with wAP

Posted: Fri Oct 30, 2015 4:58 am
by Aegis13
I just bought one of the new wAP, and I'm trying to set it up as a CAP to my RB951G-2HnD. I've previously had a Groove and a Basebox2 hooked up on the RB951 with no issues, so the CAPsMAN config should be solid.

Both wAP and RB951 are running 6.32.3. The wAP says "Managed by CAPsMAN" under the wireless interface, but does not show the second line (radio freq, channel width, etc.) like the groove and basebox did. It's also not showing up in CAPsMAN under interfaces or remote cap. (Only the internal 951 interface showing).

I used the radio interface to login and configure the wAP initially, so I know the radio interface isn't bad.

I've tried adding the wAP's wireless MAC manually, as well as using 00:00:00:00:00:00.

Anyone have a suggestion?

Thank you

Re: CAPsMAN issue with wAP

Posted: Fri Oct 30, 2015 5:33 am
by scampbell
Please check you have the same wireless package installed on all devices. e.g wireless-cm2

/system packages print

Re: CAPsMAN issue with wAP

Posted: Fri Oct 30, 2015 5:46 pm
by Aegis13
Interesting. The same package was installed but wireless cm2 was disabled for some reason on the wAP. Enabled it and all is fine.

Thank you for the help. :D

Re: CAPsMAN issue with wAP

Posted: Sun Nov 01, 2015 11:49 pm
by scampbell
You are welcome and thanks for the rating :-)