Tx/Rx Signal Strength: When aligning the endpoints you want this as high as possible ( -40 to -65 dBm say)
Tx/Rx CCQ: This shows how many packets get through , so 50% means half are getting dropped. Good TX/RX Signal and poor CCQ is a sign of interference - try a different channel
Signal To Noise: The higher the number the better. Low S/N means interference and will adversely affext performance (>40dB )
Wireless Protocol: This should match - usually NV2 or 802.11 on an AP/Bridge, and I set nstream-nv2-802.11 on a station. NB NV2 does not use your security profile so be sure to enable NV2 security on both ends if using this protocol.
The actual TX/RX Signal is a function of TX Power, Aerial gain, frequency and distance - Mikrotik have a wireless calculator on their download page to help you work out what you should be getting. Use MCS7 values for TX Power and RX sensitivity values.
Last edited by scampbell
on Thu May 05, 2016 8:35 am, edited 1 time in total.
MTCNA, MTCWE, MTCRE, MTCTCE, MTCSE, MTCINE, Trainer
Mikrotik Distributor - New Zealand