Over a station wds --> birdge
Where i should edit the security profile,
I want to set WPA2 and AES, the best encryption.
the manual doesnt show any example with wpa2
Community discussions
L
R
How to configure a WPA2 over a bridge
Last edited by HellMind on Thu Oct 12, 2006 7:24 pm, edited 1 time in total.
Documentation shows how to setup WPA encryption,
http://www.mikrotik.com/docs/ros/2.9/in ... #4.13.21.7
things to change to enable WPA2, 'mode=wpa2-psk', use 'wpa2-pre-shared-key' and 'chiphers=aes-ccm'.
http://www.mikrotik.com/docs/ros/2.9/in ... #4.13.21.7
things to change to enable WPA2, 'mode=wpa2-psk', use 'wpa2-pre-shared-key' and 'chiphers=aes-ccm'.
The latest RouterOS version contains 'authentication-mode=wpa2-psk' (use [Tab] button to check the available commands).
'mode=dynamic-keys' is required together with authentication-mode=wpa2-psk.
'interface wireless set wlan1 security-profile=' (push [Tab] button to see the available security profiles, full information about security-profile 'interface wireless security-profile print'.
Client should have the same authentication options (mode, key etc.) as the access point for successfull communications.
'mode=dynamic-keys' is required together with authentication-mode=wpa2-psk.
'interface wireless set wlan1 security-profile=' (push [Tab] button to see the available security profiles, full information about security-profile 'interface wireless security-profile print'.
Client should have the same authentication options (mode, key etc.) as the access point for successfull communications.
Who is online
Users browsing this forum: No registered users and 22 guests