Page 1 of 1

Select between b/g and clients drop

Posted: Fri Nov 03, 2006 5:41 pm
by mperdue
I have sanyo radio's and there is an optionto run 802.11b/g or 802.11b only or 802.11g only.

At the moment I have selected 802.11b and whenever I select 802.11b/g all the b clients drop. Is this normal or I am I not understanding the way b/g is suppost to work?

-Michael

Posted: Fri Nov 03, 2006 9:41 pm
by ejansson
If you ap is in b and g mode both type of clients should be able to attach. However if any b client attaches, communications to you g clients will be draged down to that of a b client. The higher through put on g require a better signal to noise ratio, so in a noisy enviroment g clients may not attach if you have disabled some of the lower speeds. But if your set up is correct there should be no reason the clients drop.