Hi all,

Yesterday I setup point to point bridge with two SXT 5 AC device but I have problem with bandwith.
Max bandwith is 170 Mbps when I copy files through bridge. Test bendwith in mikrotik say around 125mbps. Ping is excelent 1,2 or 3 ms. CCQ is around 90-100%
I try change all canals, but nothing better. I tried to change all protocols (nstreme, nv2, 802.11), but max bandwith is 170mbps.
Link distance is 750m.

Need help.

Try 40Mhz. It goes up to 250mbps for me.

Yes I tried 40Mhz, but nothing better bandwith. I don't have idea why is this happening because signal is excellent.

1. Dont use WDS use AP/Bridge to Station Bridge
2. How much is your EIRP?

Can you explain me how to use Ap bridge without WDS, what is EIRP? Where I can find this information?

Use Bridge and Station Bridge.

When I use Station bridge on clint side no connection between devices. Need I to configure something extra.

Ok. I understand. You can see in picture AP side is bridge, when I put client side to station bridge, no connection between devices.

You can see in picture AP side is bridge.

I can't see that.
Anyway you have made a mistake somewhere. Maybe the interfaces are not in bridge mode?

Sorry, yes interfaces in bridge mode now. Now I use WDS and bridge interfaces. I will post configuration when chhange to station bridge.

I tried bridge and station bridge. Device connected but no ping between. Do I have to config something else. Disable WDS or something?

This setup doesn't work. I don't know why.

You Need to Creative a Bridge with ether and wlan Interface

Need I add Ip adress on wlan, eth1, bridge?? Can this work without ip address?

Bridge does not need to have ip configured to be able to work as bridge...

OK tnx. Today I successfully setup PTP. Speed is better, but I have one question.
When I transfer data in one way speed is 400mbps in oposite way speed is 300mbps.

Bridge->Station bridge 300mbps
Station bridge->Brige 400mbps

Whay speed is different?

In Most Cases you Hage more Interference on one site, take a Look at ccq

CCQ is around 80-95%.

CCQ is around 80-95%.

Did you try changing wireless protocol?For me nv2 nstreme works the best, i have older SXT 5gz and im getting 130mbit speeds over 1KM link.

Yes I try changeing wireless protocol, but best performance I have on 802.11.
400mbps one way, 300mbps opposite way.

Yes I try changeing wireless protocol, but best performance I have on 802.11.
400mbps one way, 300mbps opposite way.

If you get 400mbps real throughput than where is the problem?Dont expect to get 600+, thats just link speeds you will never reach that.

Problem is one way is 400mbps oposite way 300mbps. Why oposite way is slow 100mbps.

I know now 400mbps is max.

Don't relay on internal btest.

Internal test and real test tell same. I tried copy data over link and speed is 400 and 300mbps. Depend on way.

Internal test and real test tell same. I tried copy data over link and speed is 400 and 300mbps. Depend on way.

Maybe you have some network in close proximity to that other side on same/near frequencies?
Try running frequencies usage scan on both sides and set it to lowest used channel.

Scan tell me frequency 5765 is no used. I try put this frequency problem is same. Speed is no better.
How I can know what is best frequency for me? I tried randomly few frequencies but speed is same or bad.

And what Frequencys are used?

This tell me Frequency usage and wireless snooper.

With Noise of Otter WIFI Routers you are Never getting the Maximum Data Rates!