Hello, first time poster, despite writing plenty of Mikrotik guides. I'm finally gotten stuck.
Thank you for taking the time to read and any constructive help is greatly appreciated.
On two separate installs now, one with a router of a CCR1036, and now a RB2011, I cannot get CAPsMAN to deploy a WAP AC that broadcasts both 2.4GHz and 5GHz frequencies. It used to not be an issue on the international version, however, we can now only obtain United States edition WAP ACs, which are in country code "united states 3".
I can connect just fine on either SSID, I get full connectivity, but 5GHz simply will not broadcast.
I receive the error, photo attached:
no supported band, radio locked to country 'united states 3'
Running Firmware 6.40.2 (Stable)
Setting:
Configuration 1 - 2.4GHz
Channel: 2.4GHz, 20MHz Control Channel, Band 2ghz-g/n, Extension Channel Disabled, Tx Power: 18dB.
Configuration 2 - 5GHz
Channel: 5GHz, 20MHz Control Channel, Band 5Ghz-a/n/ac, Tx Power: 18dB
Skip DFS Checked (didn't work unchecked either)
Provisioning
Action: Create Dynamic Enabled
Master Configuration: Configuration 1
Slave Configuration: Configuration 2
Setting up the WAP AC as a standalone unit works fine. However, I have 40 WAP ACs I need to provision, and it doesn't make sense to configure 40 independent units, hence CAPsMAN.
Hoping there is something simple I'm missing, thank you for any help you may provide. Thanks!