Community discussions

 
mbosnic
just joined
Topic Author
Posts: 1
Joined: Fri Sep 22, 2017 12:17 pm

Transparent WiFi AP

Fri Sep 22, 2017 12:45 pm

Hello.

I am trying to configure Mikrotik Groove 52HPn as an access point for a UDP camera stream (3 cameras to be exact). Cameras are connected by ethernet cable to Cloud Router Switch CR112-8G-45-IN. Groove is also connected with ethernet cable to that switch. Switch is unconfigured and is working as needed. PC1 is receaving stream from cameras without any problem. Cameras are broadcasting UDP RTP stream.
network.jpg
Groove is configured as ap-bridge, with a bridge configured on both ethernet and wlan interfaces.
wlan.JPG
ethernet.JPG
bridge.JPG
However, the streams are not showing on PC2. What am I doing wrong with this configuration?
You do not have the required permissions to view the files attached to this post.
 
User avatar
pukkita
Trainer
Trainer
Posts: 2982
Joined: Wed Dec 04, 2013 11:09 am
Location: Spain

Re: Transparent WiFi AP

Fri Sep 22, 2017 3:06 pm

Try this:

- Go to Wireless, open wlan1-gateway, click on [Advanced Mode] button, and set Multicast Helper to full.
Simplicity is the Ultimate Sophistication - Da Vinci
Getting the most out of this forum
 
scampbell
Trainer
Trainer
Posts: 446
Joined: Thu Jun 22, 2006 5:20 am
Location: Wellington, NZ
Contact:

Re: Transparent WiFi AP

Mon Sep 25, 2017 1:44 am

You might also wish to set the Wireless Protocol to 802.11 instead of "any" :-)
MTCNA, MTCWE, MTCRE, MTCTCE, MTCSE, MTCINE, Trainer
___________________
Mikrotik Distributor - New Zealand
http://www.campbell.co.nz

Who is online

Users browsing this forum: No registered users and 18 guests