I have a less 10 Kms link with two netmetals and the mikrotik parabolic mANT30. 6.39.3 routeros version.
Config both sides (one bride another station bridge):
set [ find default-name=wlan1 ] adaptive-noise-immunity=ap-and-client-mode antenna-gain=3 band=5ghz-onlyac basic-rates-a/g="" channel-width=\
20/40/80mhz-eCee default-forwarding=no disabled=no frequency=5800 frequency-mode=superchannel ht-basic-mcs=\
mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10,mcs-11,mcs-12,mcs-13,mcs-14,mcs-15 hw-retries=15 max-station-count=1 mode=\
bridge nv2-cell-radius=10 nv2-security=enabled rate-set=configured rx-chains=0,1 scan-list=\
5100-5900 security-profile=RedSL supported-rates-a/g="" tdma-period-size=auto tx-chains=0,1 vht-supported-mcs=mcs0-7,mcs0-7,none \
/interface bridge port
add bridge=bridge1 interface=wlan1
add bridge=bridge1 interface=ether1
/interface bridge> print detail
Flags: X - disabled, R - running
0 R name="bridge1" mtu=auto actual-mtu=1500 l2mtu=1600 arp=enabled arp-timeout=auto mac-address=6C:3B:6B:4A:00:CC protocol-mode=rstp fast-forward=yes
priority=0x8000 auto-mac=yes admin-mac=00:00:00:00:00:00 max-message-age=20s forward-delay=15s transmit-hold-count=6 ageing-time=5m
Signal TX/RX: -32/-29 db (I have also tried to lower the power of the signal to -40 db and the throughput also low)
protocol 802.11ac (nv2 and nstream worst result)
Test from CCR to a RB912uag: CCR <--->netmetal1 (( )) netmetal2<-->RB912uag
Where are the missing 200Mbps? at least.
Or is that the normal behaviour?
I don't know what to do (in addition to changing equipment). Does anybody have any suggestions?
Thanks in advance.