So I've noticed a substantial difference in setting a wap60 to bridge vs ap-bridge.
Currently this wap60 is a ptp link and I am in the process of converting it to ptmp. However my existing client keeps on flapping. I upgrading to the latest RC (on both sides) and noticed a huge difference.
mode=bridge
Code: Select all
interface w60g station monitor wlan60-station-2
connected: yes
remote: 30:07:4D:84:A0:74
mcs: 7
phy-rate: 1925.0Mbps
signal: 60
rssi: -70
tx-sector: 14
tx-sector-info: left 19 degrees, down 19 degrees
rx-sector: 96
distance: 199.24m
Code: Select all
interface w60g station monitor wlan60-station-2
connected: yes
remote: 30:07:4D:84:A0:74
mcs: 2
phy-rate: 770.0Mbps
signal: 35
rssi: -70
tx-sector: 14
tx-sector-info: left 19 degrees, down 19 degrees
rx-sector: 96
distance: 199.23m
PHY & MCS rate is MUCH lower by only changing the mode. Wondering if anyone else is seeing this?