TDM over IP (Wireless) help

mksb · Sat Jan 27, 2007 9:06 pm

we are tryig to carry E1 signal from TDM over IP device to a remoe area 3km away but we are not getting any throughput for E1, whereas in wireless circuit we are getting well over 6Mb, on futhe analysis we saw that on transmission of data the Rxor Tx always go below 2Mb(which is E1 ofcourse) and we loose E1 sync.

Can anyone suggest a way by which we can make Tx:Rx = 1:1 and with minimum 2mb on both Tx and Rx???

bushy · Sun Jan 28, 2007 1:40 am

I think you need to use Nstreme 2 to make a full duplex radio link first . Last time i looked at tdms ( over non-mikrotik links) they weren't too happy.

mksb · Sun Jan 28, 2007 4:35 pm

Bushy,
would like to know if Nstrem single is full-duplex or not???

tneumann · Sun Jan 28, 2007 4:47 pm

Standard nstream is half-duplex. The main point of nstream2 compared to nstream is to make it possible to build full-duplex links...

--Tom

mksb · Mon Jan 29, 2007 7:54 pm

hi,

the TDM worked thanks
Want to know something I am getting a latency of 47-73ms is this ok???

bushy · Tue Jan 30, 2007 12:23 am

Mksb ,
Did you use Nstreme 2 to make the Tdms work better ?

mksb · Tue Jan 30, 2007 7:24 am

hi,
TDMs are working finally without any breakage in Ethernet signal but latency is high , in cross over cable the latency was about 46ms constant, in case of wireless it varies between 47-73ms just wanted to know if this is ok???

tneumann · Tue Jan 30, 2007 11:57 am

If you're seeing 46ms latency on a wired ethernet link (crossover cable) then either the CPU of your routers is maxed out or you are having serious problems on that ethernet link (bad cable, failed auto-negotiation, duplex mismatch etc.)

Latency should be much lower under normal conditions.

--Tom

mksb · Thu Feb 01, 2007 9:25 am

my TDMs have finally got in sync with radios (NSTREME - DUAL) but there is no transmission of voice at the remote end can someone tell me what the problem is???

Dina · Wed Aug 01, 2018 1:55 am

hi everyone I am new here and I find a problem in TDM over IP in my mikrotik netmetal please help me
with configuration detail

TDM over IP (Wireless) help

TDM over IP (Wireless) help

Re: TDM over IP (Wireless) help

Who is online