viewtopic.php?t=71564&sid=b1c1c348d2035 ... ecf04b8a61
But when I do the changes CCQ rise up to 100% both rx/tx, one hour later it drop to 40%.... tried to change frequencies with no luck....
This is my export from ptp AP.... STA has the same config (but in STA config)... the links has full line of sight
Code: Select all
# may/06/2019 09:37:21 by RouterOS 6.43.2
# software id = xxxxxxx
#
# model = SXT 5nD r2
# serial number = xxxxxxxxx
/interface bridge
add fast-forward=no name=bridge1
/interface wireless
set [ find default-name=wlan1 ] ampdu-priorities=0,1,2,3,4,5,6 antenna-gain=10 \
band=5ghz-a/n basic-rates-a/g="" country=spain default-forwarding=no \
disabled=no frequency=5280 frequency-mode=regulatory-domain ht-basic-mcs="mc\
s-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10,mcs-11,mcs-\
12" ht-supported-mcs="mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,\
mcs-9,mcs-10,mcs-11,mcs-12" mode=bridge nv2-preshared-key=\
nv2-password nv2-security=enabled radio-name=ptp-air rate-set=\
configured ssid=ptp-air supported-rates-a/g="" wireless-protocol=nv2
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTik
/interface bridge port
add bridge=bridge1 interface=wlan1
add bridge=bridge1 interface=ether1
/ip address
add address=172.16.126.30/23 interface=bridge1 network=172.16.126.0
/ip route
add distance=1 dst-address=172.16.127.254/32 gateway=bridge1
/ip service
set telnet disabled=yes
set ftp disabled=yes
set ssh disabled=yes
/system identity
set name=ptp-air