Page 1 of 1

rx rate problem

Posted: Mon May 13, 2019 1:45 am
by s0una
hello can someone help me with this problem i have to mikrotik links with a good ccq and signal but everyday signal drops from -50 to -39 and rx rate from 180 tp 86

Re: rx rate problem

Posted: Mon May 13, 2019 1:47 am
by s0una
first pic

Re: rx rate problem

Posted: Mon May 13, 2019 2:34 am
by s0una
now

Re: rx rate problem

Posted: Mon May 13, 2019 8:13 pm
by mkx
Signal actually rises from -50 to -39 (when measuring signal strength, more is more and -39 is less negative than -50, hence better signal). Is the Rx rate observed while link is utilized or (almost) idle? If while it's idle, then the number is meaningless...

Re: rx rate problem

Posted: Mon May 13, 2019 10:28 pm
by s0una
thanks for replying i know -39 is better tahn -50 by negative sign but my signal is -50/-51 for example when it became -39/-51 rx rate drops to 86 my bandwidth is 100 mb when it drops it will only be 40 to 50 mb

Re: rx rate problem

Posted: Mon May 13, 2019 11:16 pm
by mkx
Actually I think that signal strength higher than around -45 is too strong and causes distortions in the receiver (driving pre-amp into non-linear range) causing drop in signal-to-noise ratio and hence reduced throughput. Try to maintain signal strength above -45 or -50 dBm.

Re: rx rate problem

Posted: Tue May 14, 2019 12:12 am
by s0una
this is my signal i think it is good but what happens with me is that sometimes signal changes for -39 and it will make problems and after a few minutes it will raise alone

Re: rx rate problem

Posted: Wed May 15, 2019 10:54 pm
by s0una
any help?

Re: rx rate problem

Posted: Thu Jun 20, 2019 11:53 pm
by s0una
????

Re: rx rate problem

Posted: Fri Jun 21, 2019 12:58 am
by CZFan
????

Did you see the suggestion from @mkx posted 13 May?