Community discussions

MUM Europe 2020
 
milad7
just joined
Topic Author
Posts: 2
Joined: Mon Dec 02, 2019 11:47 pm

Very low performance with omniTIK 5 ac and SXT Lite5

Tue Dec 03, 2019 12:06 am

Hi guys

I have an omniTIK 5 ac and two SXT Lite5 and I'm going to set up the PTMP scenario.
Omnitik is installed in HQ and SXTs in branches.
Distances between the HQ office and branches are 70 and 170 meters. I could install one link so far which has awful CCQ and Tx/RX strength.
you can see the status as attached, current throughput is very low!!!!!!!!!
would you please help me to increase the performance?
You do not have the required permissions to view the files attached to this post.
 
Rudolfs
MikroTik Support
MikroTik Support
Posts: 8
Joined: Fri Jun 01, 2018 8:57 am

Re: Very low performance with omniTIK 5 ac and SXT Lite5

Tue Dec 03, 2019 10:54 am

Hello,
Try enabling 5Ghz-a/n band in wireless settings if you are using SXT Lite5 on the other side. If the issue with low throughput still remains, I recommend generating supout.rif files on the AP and on one or both station devices and send them to support@mikrotik.com
https://wiki.mikrotik.com/wiki/Manual:S ... utput_File
 
quackyo
Member Candidate
Member Candidate
Posts: 113
Joined: Mon Nov 16, 2015 10:14 am

Re: Very low performance with omniTIK 5 ac and SXT Lite5

Tue Dec 03, 2019 11:01 am

Bad signal. Increase signal is the only answer.
Do this by removing obstacles, interference (change channel?), raise one or both end of the links higher, and possibly dump the omni in the middle and use something at least partly directional.
 
mkx
Forum Guru
Forum Guru
Posts: 3351
Joined: Thu Mar 03, 2016 10:23 pm

Re: Very low performance with omniTIK 5 ac and SXT Lite5

Tue Dec 03, 2019 11:16 am

Bad signal. Increase signal is the only answer.

In particular bad signal on Ch0 ... either Ch0 antenna is (semi-)defunct or there's some obstacle in the Fresnel zone which has polarizing properties and affect one polarity much more than the other.
BR,
Metod
 
milad7
just joined
Topic Author
Posts: 2
Joined: Mon Dec 02, 2019 11:47 pm

Re: Very low performance with omniTIK 5 ac and SXT Lite5

Wed Dec 04, 2019 12:58 am

Hello,
Try enabling 5Ghz-a/n band in wireless settings if you are using SXT Lite5 on the other side. If the issue with low throughput still remains, I recommend generating supout.rif files on the AP and on one or both station devices and send them to support@mikrotik.com
https://wiki.mikrotik.com/wiki/Manual:S ... utput_File
thanks for reply
I sent two support files to above email address.
awaiting for response

Who is online

Users browsing this forum: No registered users and 18 guests