Code: Select all
ranges: 2402-2482/b,g,gn20,gn40(20dBm)
2417-2457/g-turbo(20dBm)
5170-5250/a,an20,an40,ac20,ac40,ac80,ac160,ac80+80(23dBm)/passive,indoor
5170-5330/a,an20,an40,ac20,ac40,ac80,ac160,ac80+80(20dBm)/dfs,passive,indoor
5250-5330/a,an20,an40,ac20,ac40,ac80,ac160,ac80+80(20dBm)/dfs,passive,indoor
5490-5710/a,an20,an40,ac20,ac40,ac80,ac160,ac80+80(27dBm)/dfs,passive
5190-5310/a-turbo(20dBm)/dfs
5180-5300/a-turbo(20dBm)/dfs
5520-5680/a-turbo(27dBm)/dfs,passive
5510-5670/a-turbo(27dBm)/dfs,passive
902-927/b,g,g-turbo,gn20,gn40(30dBm)
Code: Select all
/interface wireless monitor [find default-name=wlan1] once
status: running-ap
channel: 2437/20/gn(18dBm)
wireless-protocol: 802.11
noise-floor: -95dBm
overall-tx-ccq: 81%
registered-clients: 1
authenticated-clients: 1
wmm-enabled: yes
current-tx-powers: 1Mbps:15(15/18),2Mbps:15(15/18),5.5Mbps:15(15/18),11Mbps:15(15/18),6Mbps:15(15/18),9Mbps:15(15/18),12Mbps:15(15/18),18Mbps:15(15/18),24Mbps:15(15/18),36Mbps:15(15/18),48Mbps:15(15/18),54Mbps:15(15/18),HT20-0:15(15/18),HT20-1:15(15/18),HT20-2:15(15/18),HT20-3:15(15/18),HT20-4:15(15/18),HT20-5:15(15/18),HT20-6:15(15/18),HT20-7:15(15/18)
notify-external-fdb: yes
As a test, if the antenna gain is defined to be as an example 10dB, the reported "Total Tx Power" is reduced to 10dBm so, it seems the effect of the antenna gain is being subtracted to the "Total Tx Power" instead to the "Tx Power" (card).
I also don't understand the origin of the 3dB difference reported between the "Tx Power" and the "Total Tx Power" it should be the antenna gain no? ...
This results in worst conditions of connectivity to Mikrotik devices as compared to other manufacturers in similar conditions.
Our users are pointing to the Mikrotik devices telling "the signal were better with the old network" ...
regards.