I'm trying to set up a CAP AC to use VLANS, one for private staff WiFi and ethernet LAN and another VLAN for guests WiFI only.
I have a HEX configured with 2 VLANS, vlan100 wich has a DHCP 192.168.2.1/24 and vlan200 wich has DHCP 10.11.12.1/24 both on eth2 port, trunk port.
What I'm trying to do is get eth1 of CAP AC as trunk port, Staff WiFi on VLAN100, Guests WiFi on vlan200 AND eth2 port of the CAP AC as access untagged port with vlan100 so I can connect another device like a PC that the staff uses.
I managed to get almost everything working using this guide, did all steps under R2 section - https://wiki.mikrotik.com/wiki/Manual:VLANs_on_Wireless but I can't get eth2 port of the CAP AC to act as access port carying vlan100 only.
I'm attaching a diagram Here is my config:
interface bridge print Flags: X - disabled, R - running 0 R name="bridge1" mtu=auto actual-mtu=1500 l2mtu=1598 arp=enabled arp-timeout=auto mac-address=C4:AD:34:8D:2C:4A protocol-mode=rstp fast-forward=yes igmp-snooping=no auto-mac=yes ageing-time=5m priority=0x8000 max-message-age=20s forward-delay=15s transmit-hold-count=6 vlan-filtering=yes ether-type=0x8100 pvid=1 frame-types=admit-all ingress-filtering=no dhcp-snooping=no interface bridge vlan print Flags: X - disabled, D - dynamic # BRIDGE VLAN-IDS CURRENT-TAGGED CURRENT-UNTAGGED 0 D bridge1 1 bridge1 ether1 ether2 1 bridge1 100 ether1 ether2 2 bridge1 200 ether1 interface bridge port print Flags: X - disabled, I - inactive, D - dynamic, H - hw-offload # INTERFACE BRIDGE HW PVID PR PATH-COST INTERNA... HORIZON 0 ether1 bridge1 yes 1 0x 10 10 none 1 I wlan1 bridge1 1 0x 10 10 none 2 I wlan2 bridge1 1 0x 10 10 none 3 ether2 bridge1 yes 1 0x 10 10 non