I am planning to replace my Aruba Instant-On with Audience. It is a 3band Ap, however, can the 3rd 1733 Mbit/s band be assigned to clients or it is only for mesh between Aps?
Thank you for your advice, in terms of frequencies for the 3rd band which I slightly higher than standard 5Ghz, would the clients be able to see that network?
Hi so on my Audience I wish to use wlan3 for the lower 5Ghz frequencies, but selection field (I use winbox) currently only allows 5500 - 5825 Mhz as options (in 20Mhz width) how do I change this to allow 5180Mhz (Channel 36) and above, and therefore the full 5Ghz range on this wlan3 radio?
No, you cannot. Wlan3 is usable only with that frequency range. In a topic somewhere in here, someone stated that even if you could bypass this limitation via software, there's also some-sort of a hardware lock. So, for channel 36, use wlan2.