LHG-LTE6 Running OS 6.47.3. - - The R11e-LTE6 firmware has been updated to latest v025. - - APN: broadband
So after a bit of experimentation in several different locations oriented towards different known AT&T tower sites, it seems that while I can connect to each of these three bands (B2, B12, B17) separately (by selecting the individual Band within the LTE Interface).
When I do not select a specific LTE Band in the LTE Interface, it immediately locks onto B2... which may or may not be the best performing band in the area.
And then it does nothing more than stay on B2.... Once in awhile, it tries to select B17 or B12 as the CA Band, albeit momentarily.
After a minute or less it simply disconnects from the chosen CA Band and never tries to connect a CA again, however, B2 stays connected.
I'm guessing that I'm not setting this up properly or I'm not selecting something properly...?
I have tried different variations of selecting all GSM, 3G and LTE, selecting 3G and LTE, and I have tried just selecting LTE.
As for the LTE Bands, am I supposed to tick off (select) ALL of the LTE Bands that I wish to possibly connect to (in this case B2, B12 and B17)?
Or, am I only supposed to select the Primary CA LTE B2 and let the R11e-LTE6 modem negotiate the CA with another channel on it's own?
OR... Do I simply NOT select any of the LTE Bands and let it do everything on it's own?
Doesn't seem to matter what I do, I cannot get CA to operate when I know that the other Bands are present and can be connected to individually.
ANY Insight, Direction and Guidance would be appreciated!
Thank You!