I'm kinda of a newbie with the Mikrotik configs. If you anyone could help me figure out why I have performance issue with my config I would be very grateful.
The topology is as follows:
AP > CRS326 > RB3011 > Internet
I have a line of 100Mbps from my ISP.
Machines (Physical or virtual) connected to CRS326 are getting speeds to the outside world between 75 and 100Mbps.
Devices (Several tested as Laptops, Mobile Phones etc) connected to the AP get top speed of 30Mbps on the 2GHz Band. The issue is persistent, but it wasn't the case when I installed and configured the device. Since then small changes are being made as MGMT VLAN config. I've faced the same issue once before (the Mikrotik had default Router config) when I reset the config with "no default" and configured the device the issue was gone.
I do not see any CPU issues. I have around 10 devices connected. Speed tests are performed with single device connected.
Here's my Mikrotik AP Config:
Code: Select all
# apr/05/1970 04:40:53 by RouterOS 6.44.5
# model = RBwAPG-5HacT2HnD
/interface bridge
add name=Bridge-LAN vlan-filtering=yes
/interface vlan
add interface=Bridge-LAN name=MGMT-vlan9 vlan-id=9
/interface list
add name=WAN
add name=LAN
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTik
add authentication-types=wpa-psk,wpa2-psk eap-methods="" management-protection=allowed mode=dynamic-keys name=QUERTY supplicant-identity=""
/interface wireless
set [ find default-name=wlan1 ] band=2ghz-b/g/n disabled=no installation=indoor mode=ap-bridge name=wlan2g security-profile=QUERTY ssid=KAF2Ghz
set [ find default-name=wlan2 ] band=5ghz-a/n/ac disabled=no installation=indoor mode=ap-bridge name=wlan5g security-profile=QUERTY ssid=KAF5Ghz
/ip hotspot profile
set [ find default=yes ] html-directory=flash/hotspot
/interface bridge port
add bridge=Bridge-LAN interface=ether1
add bridge=Bridge-LAN interface=wlan2g pvid=30
add bridge=Bridge-LAN interface=wlan5g pvid=30
/ip neighbor discovery-settings
set discover-interface-list=none
/interface bridge vlan
add bridge=Bridge-LAN tagged=ether1 untagged=wlan2g,wlan5g vlan-ids=30
add bridge=Bridge-LAN tagged=Bridge-LAN,ether1 vlan-ids=9
/interface list member
add interface=wlan5g list=LAN
add interface=ether1 list=LAN
add interface=wlan2g list=LAN
/ip address
add address=10.9.9.3/24 interface=MGMT-vlan9 network=10.9.9.0
/ip route
add distance=1 gateway=10.9.9.1
/ip service
set telnet disabled=yes
set ftp disabled=yes
set www disabled=yes
set ssh port=2222
set api disabled=yes
set winbox address=10.9.9.0/24
set api-ssl disabled=yes
/tool mac-server
set allowed-interface-list=none
/tool mac-server mac-winbox
set allowed-interface-list=none
/tool mac-server ping
set enabled=no
[code]