I am new to Mikrotik and trying to set up a wAP 60g aP with a point to multipoint. I need an address of 10.1.1.13/24 with a gateway of 10.1.1.2. as the management VLAN. This AP is Connected to a Switch that is set to a Trunk port. on the other side, I have a wAP 60g that is connected to a switch with a trunk port. When I use the Quickset on the AP I put my SSID in and IP I cannot see the AP on the network with Winbox. If I connect the AP to my computer directly I can see both sides it is only when I put it back on my switch I cannot see it. Do I need to do something with vlan's on the AP? Please help with any suggestion.