Page 1 of 1

which is the best config to bridge two networks with a p2p l

Posted: Fri Jul 06, 2007 8:19 pm
by kolorasta
i want to make bridge 2 networks with a p2p link. Which is the best config?

i'm using the example that's in the wiki, but i want to know if there is a better way or is this the best way?

i have only one minipci in each point. I say that because i have read that you can make mice links with two ratios in each point.
i can see also in the config that there are differents bands to work with, 5Ghz, 5Ghz Turbo, 5Ghz-10Mhz, 5Ghz-5Mhz. where can i find some info about this?

Any suggestions?

Re: which is the best config to bridge two networks with a p2p l

Posted: Thu Jul 12, 2007 1:17 am
by sokolov
better way is to route traffic between them.

Zarko
SkopjeWirelessNetwork
Macedonia

Re: which is the best config to bridge two networks with a p2p l

Posted: Thu Jul 19, 2007 11:49 am
by serthan
i realy wonder that. i am trying to link 2 network, what a fulish Board that i ever seen :)

working hard if i found the config will share with you.

Best Regard

Re: which is the best config to bridge two networks with a p2p l

Posted: Thu Jul 19, 2007 2:57 pm
by kolorasta
thanks serthan