This link is bouncing up/down every 15 minutes.
60G Cube Lite to WAP 60:
/interface w60g> monitor 0
tx-sector-info: right 0.4 degrees, up 1.8 degrees
If you monitor for 30 seconds, you'll see the signal, rssi and tx-phy-rate values bounce around a bit. This is a clear line of sight with no obstructions on the roof of two buildings way above street level.
The CPE is
board-name: Cube Lite60
board-name: wAP 60G AP
Any suggestions? Is there a preferred firmware?