and found some same(?) issue here without clear soluction:
DHCP client - wlan as WAN not getting address viewtopic.php?t=128954
DHCP client on bridge does not work? viewtopic.php?t=133156
Wireless clients can't get an IP viewtopic.php?t=149949
after some dig, I found DHCP client fail only on 2.4G port, 5G port works fine (which is from the same ap)
config here:
Code: Select all
/interface wireless
set [ find default-name=wlan1 ] allow-sharedkey=yes band=2ghz-b/g/n channel-width=20/40mhz-XX country=no_country_set disabled=no frequency=auto frequency-mode=superchannel ssid=CISCO station-roaming=\
enabled wireless-protocol=802.11 wmm-support=enabled
set [ find default-name=wlan2 ] band=5ghz-a/n/ac channel-width=20/40/80mhz-XXXX country=no_country_set distance=indoors frequency=auto frequency-mode=superchannel ssid=CISCO station-roaming=enabled \
wireless-protocol=802.11 wmm-support=enabled
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa2-psk eap-methods="" mode=dynamic-keys supplicant-identity=MikroTik wpa2-pre-shared-key=some_password
/ip dhcp-client
add disabled=no interface=wlan1
add disabled=no interface=wlan2
wlan1 keep searching but wlan2 can get a address from dhcp.
any ideas?