Hi,
before I started to take the step to write.. I'm been googling for hours. Been searching your website for answers.. and now hope anyone can help me.
I've purchased 2x cAP ac to cover my cabin. My plan is to use them as _only access points with no dhcp_..
I though this was going to be as easy as ubiquiti or deco m5 or similar.. but I did not read up on mikrotik,. BUT that's no worries, I like to fiddle with this and make it work.
Already put firewall changes to be able to access the web-console from LAN port. (yes, this does not work by default ;))
Anyway.. my problem is that 5GHz is not working.
I've only unpacked one device.. and not sure I want to unpack the other If I have to return them.. I like to get this working before I unpack the next device. But if I cannot get it to work, I will try to open the other device too and see if the same happens to this device.
I have tried resetting the device several times, _and_ waited a long time before checking, and checking again..
Iphone XR or different PCs does not see the 5GHz network. period.
I've upgraded to latest firmware.
I've tried disable/enable the wlan2.
I've tried to hide/unhide the SSID to force it to react.
I've tried to wait, and wait.. for something to happen but no..
I've SSH, and printet out this, which is the default values:
[admin@MikroTik] /interface wireless> print
Flags: X - disabled, R - running
0 R name="wlan1" mtu=1500 l2mtu=1600 mac-address=2C:D9:1B:BE:E2:7D arp=enabled interface-type=IPQ4019
mode=ap-bridge ssid="MikroTik-10E07D" frequency=auto band=2ghz-b/g/n channel-width=20/40mhz-XX
secondary-channel="" scan-list=default wireless-protocol=802.11 vlan-mode=no-tag vlan-id=1
wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no bridge-mode=enabled
default-authentication=yes default-forwarding=yes default-ap-tx-limit=0
default-client-tx-limit=0 hide-ssid=no security-profile=default compression=no
1 name="wlan2" mtu=1500 l2mtu=1600 mac-address=2C:D9:1B:BE:E2:7E arp=enabled interface-type=IPQ4019
mode=ap-bridge ssid="MikroTik-10E07E" frequency=auto band=5ghz-a/n/ac
channel-width=20/40/80mhz-XXXX secondary-channel="" scan-list=default wireless-protocol=802.11
vlan-mode=no-tag vlan-id=1 wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no
bridge-mode=enabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0
default-client-tx-limit=0 hide-ssid=yes security-profile=default compression=no
[admin@MikroTik] /interface wireless>