I'm struggling with the VLAN configuration. My Mikrotik AP's are behind a HP switch with 2 VLAN's and the default VLAN.
I want to have 2 WIFI networks (2 SSIDs) with each of them there own VLAN.
The Mikrotik AP is managed by the CAPSManager.
I'm struggling where to configure the VLAN (in CAPsManager, on the local AP, etc). I see it is possible in:
- Capsmanager - Datapaths,
- Capsmanager - Configuration - Datapath.
- Caps - Interface List - VLAN
And how should the HP switch, the port to which the Mikrotik AP is connected to, configured, tagged, untagged......
The router behind the HP switch is handing out the IP addresses based on the VLAN connection. Currently I don't get a IP belonging to the VLAN I specify in the Mikrotik.
I tried many different configurations but didn't found the correct working config.
Any suggestions on how I should set this up? Do you need more info from me about the current setup?