It's a tribute to MikroTik that I only have to ask a question every two years! The down side is I still don't really understand...
A new CAP ac is powered up - I log in on 192.168.88.1
I set up a simple access point using WISP.
I tell it to get IP addresses from the Eth 1 over the LAN
I configure the wireless and add passwords etc.
All is good the wireless works - the router (BT Smart Hub 2 - I'm in the UK) behind the switch behind the CAP provides DHCP and all is fine.
Now I want to change a setting, how do I log into the CAP? I can't seem to find it on the 'attached devices' list of router and of course 192.168.88.1 doesn't work.
I can reset and start again but isn't there an easier way?
I tried WinBox trying to connect using the MAC address but my desktop is on a different switch and it doesn't seem to work.
ta
PH