I am new to the forum and would like to say I love Mikrotik products! they work and work well and love the regular updates they receive compared to more commercial products.
I am currently running a HAP AC2 in my living room and I am experiencing quite a bit of lag/jitter when using Oculus airlink.
I am running it on 5GHz and using the oculus about 2-3m away from the HAP AC2, signal strength is excellent (-44 dBm) and TX/RX Rate is 866Mbps. I have even tried disabling the 2.4GHz.
My PC is also connected to the router by gigabit ethernet. I live in a freestanding house with no close neighbors so WIFI interference should not be a problem.
I have tried leaving all settings at default and routerOS version is 6.47.10 long term
Code: Select all
/interface wireless
set [ find default-name=wlan1 ] band=2ghz-b/g/n channel-width=20/40mhz-XX \
disabled=no distance=indoors frequency=auto installation=indoor mode=\
ap-bridge security-profile=default ssid="VR-5GHz" station-roaming=\
enabled wireless-protocol=802.11
I fiddled with the Wireless settings for a few days and found that the best settings was 5GHz A/N with a channel width of 20/40MHz XX gave much better results, but was still not as good as the TPlink N600 AP. I also found that just using the 2.4GHz wifi gave better results than the 5GHz.
I am sure I just need to adjust some or other setting or protocol to get much better results. There are so many settings that I do not understand and I have exhausted my DIY level of knowledge around Mikrotik networking before asking the community for assistance. I would appreciate any advice and thank you in advance.