Hello everyone!
I've been searching for this situation and I've found some related posts but without any help... so I try to discuss here my problem, hoping for some solution.
We made a ptp link between our main site and the werehouse (200-300m away) using two RBSXTsqG-5acD, no obstacles between, just a plain field.
Here the configuration:
And this are the statistics of the link:
and signal
So, all looks very good and we was excited to have a ~700Mbps link (based on the rates) but then we tried to strasfer a file from the fileserver to a laptop (connectet to the remote point with a 1G eth port) end here the very bad news... the trasfer is terribly slow, 5 to 6MB/s so ~48Mbps (as indicated in the interface menu in winbox).
Both devices have cpu usage close to 0%, so it's not this the limit... With the builtin speed test we can reach 200Mbps but then the cpu reach the maximum capacity so I think it's not a usefull test.
Just for information, the same test done in the main site (same laptop, cable, file etc) reach the maximum speed possible in a 1G eth link.
I'm asking to you if you have some suggestions on how to create a good link, so we could use the other building for work, since I've spent three days without any improvements.
Almost forget... I've been able to reach 10MB/s changing the wireless protocollo from nv2 to 802.11... and this looks odd to me
Thanks to all in advant!