Hi, I have a mikrotik configured as an AP-bridge, and a remote unit configuered as station.
I managed to configure a vlan interface on the AP for administration and it works ok, but when I try to pass another vlan over de wireless interface to the remote station the equipment connected to it does not respond pings. I put a sniffer, and I see arp tagged request (.1q) paquets coming in, but my equipment (a cisco switch) does not respond them.
(I have lot of experience in cisco, and Im not wrong in configuration)
Then I change the configuration, on the station, to receive untagged, I put the sniffer again, and it happens again (I receive arp request from de cpe, connected to de AP, but this time untagged, and a simple PC does not respond the pings, nor does not get arp entries) -
It looks like a mac publication problem...Im not sure..
Then I put an IP address on every VLAN interface (Vlan interface on the ethernet, vlan interface on the wireless link (wlan1)), and what I found is that the CPEs connected to the mikrotiks, can ping only locally vlan interfaces, but not the remote vlan interfaces. All vlan interfaces have same id, and belong to same IP network.
My config is as follow:
vlan id 1900, on interfaces: eth1 and wlan1.
I create a bridge name "vname1900" Then I bridge all the vlan interfaces with id 1900 to "vname1900"
I also try to include in the bridge, wlan1 and on wds1 interface. Does anyone know why it is not workings?. Thanks-