Hi all,
I want connect a hAP ac² with an existing 2.4 GHz WLAN.
With WinBox and Quick Set, I could not choose any 2.4GHz WLAN.
So I configured a wireless connection manually.
The connection is up and running, status fine with 144MBit.
But I can not set any IP Address.
If I set with WinBox an DHCP Client, I become an error:
"Couln't change DHCP Client <wlan1> - can not run on slave interface (6)" .
Then I set it up with Terminal and I can create the DHCP client, status is bound, but the
Client entry remains red although it get a correct IP but it dosen't use it.
I take a look in the 2.4GHz router and the connection is listed with a Address from Zeroconf range 169.254.x.x
Now I set a static IP in IP>Addresses for this WLAN Interface with 192.168.179, but the same result, IP at the 2.4 Router in range 169.254.x.x!
In the end the hAP ac² should act as Router with an 2.4 GHz WLAN WAN Interface.
I hope someone has an Idea where I do any mistake.