I need to configure a MT based CPE in birdge mode in order to connect to a MT based Access Point.
On the Access Point (one eth interface and two wireless interfaces) I've created a bridge, added to it all its interfaces (eth1, wlan1, wlan2) and assigned to this an IP address.
If I connect to this AP a CPE configured as station in NAT router mode, everything works fine. Problem starts as I try to connect to the AP a CPE configured in bridge mode: I've created a bridge interface on CPE, added to this all its interfaces (eth1, wlan1) and assigned an IP address. In this situation CPE connects to the Access Point, WinBox search finds the AP, but it is not possible to connect to it.... :
Any advice? I would like to avoid EoIP or WDS...