Sat Dec 29, 2007 12:40 pm
On AP Bridge side... the bottom line said running AP
On Station side.., the botoom line said searching for network
The config on AP.. Band : 2GHz-10MHz, frequency 2407, country : no_country_set
The config on Station.. Band : 2GHz-10MHz, frequency 2407, scan-list=2400-2500, country= no_country_set
When we click scan on station, it shows...
+ testlink 2407 -36
+ testlink 2457 -86
both with the same mac address.
Why there are two lines with the same ssid and mac address but different frequencies ?
BUT when the Band of both sides change into 2.4GHz B/G or 2.4GHz-only-G, it works fine. Status on Station side shows that the signal from an AP is -36dB and scan only show 1 line.
Any clues please...
Paul