I have 2 RB 333's in a point to point scenario. We did not have this finalized and in production but I did setup the connection. One day when I was doing bandwidth tests from the station to the AP it appeared that the AP rebooted. This happened a couple of times so I planned on looking at the AP the next day. When the next day came and I was on the AP doing some further bandwidth tests it again started to reboot on me. I got back in to it and so I started looking at various settings to see if I could find something that was wrong in the config. I was looking at the different TX power settings and it rebooted again on me. Now it appears to be in an endless cycle of rebooting and Im not sure if something happened to the configuration or if something is wrong with the board itself. This board is mounted on a tower and what I would like to know is if there is a way to do a master reset from the ground and or if there is something I can do to regain access to the device. Any help would be greatly appreciated in this matter of my urgency.
PS. Feel free to pm me if you wish to ask questions and we can set something up