Running XR2 and XR5 on RB333 ROS 3.7.
Been having terrible throughout problems to my clients on this AP (XR2)
I spent considerable time testing this installation before putting it into production.
In trials all my clients connected with good throughput and connection rates.
Clients are 8186,2511,Crossroads and nanstations.
All working fine being fed by overloaded 8186.
When I put the entire group of clients over I started to see throughput problems.
Tried everything I could think off to no avail.(rebooting,b-g, b\g turned down power from default,enable disable wireless etc)
Ros went from 3.4 to 3.7 over this period ....no improvement.
Today while trying to work out why I was getting poor performance with a new Crossroads on this AP I turned the preamble from "both" to "short".
I lost all of my 2511's but my 8186,Nanstations and crossroads where all happy ,showing normal performance.
So I switched back to "both" to get my 2511's back on and was suprised that the throughput remained good for about 1/2 hour ,then went back to the previous abysmal scores.
Repeated the procedure with same results...
I'm going to try putting all my radios in Long see if it stabalizes....but f there is any one with the same xp I'd like to hear from you nothing I found in the forum search.
Cheers