Page 1 of 1

Question is very simple ....but not for me until now..

Posted: Thu Aug 13, 2009 10:50 pm
by dormador
Hi gentleman
i have 2 AP one ap bridge another station.
i need to know where is the wrong side.
see please.
AP-WDS bridge.jpg
station.jpg
where is the AP that has prb....

its the first one
or the second...

thanks for all

Re: Question is very simple ....but not for me until now..

Posted: Fri Aug 14, 2009 7:26 am
by angboontiong
Not really get what you mean...
Would you mind to share more???

Re: Question is very simple ....but not for me until now..

Posted: Fri Aug 14, 2009 4:18 pm
by dormador
angboontiong Thank you for your comment

ok look to the first AP the ccq is TX-RX: 26-98 % the second TX-RX:96-32 %

there is one from these tow AP has ccq RX:98% and TX:96% another has RX:32% and TX:26%

i want to know .... What is the AP that caused the problem (or has bad ccq)....and where the AP that hase good ccq....

I hope that the idea had been clarified

regards

Re: Question is very simple ....but not for me until now..

Posted: Fri Aug 14, 2009 6:41 pm
by angboontiong
Allow me ask some question before look into the problem of the AP..

1) It's you AP point to a "Station (which fixed and nothing do with it)"
2) It's you AP connected to external antenna?
3) The result of 2 AP you post, when you do so, it's you just take down the AP radio enclosure, then connect the AP to the same Antenna (antenna is fixed and nothing do with it)?

From there, then i can share with you on the next. ops, before that, try to use you finger touch on the wireless card heatsink, see it's warm only or very hot?

Re: Question is very simple ....but not for me until now..

Posted: Sat Aug 29, 2009 2:38 am
by dormador
thanks Mr.angboontiong for your help

after some test i know the reason
The problem from the antenna were not adjusted properly
also roundness the earth, and some plateaus they reflect some of the waves

regards

Re: Question is very simple ....but not for me until now..

Posted: Sat Aug 29, 2009 5:54 pm
by angboontiong
thanks Mr.angboontiong for your help

after some test i know the reason
The problem from the antenna were not adjusted properly
also roundness the earth, and some plateaus they reflect some of the waves

regards

Dear dormador...
Great to heard that, in fact i do nothing with you..

Happy sharing here...
:D :D :D