Can I see remote SNR directly on the "Registration TAB" of the AP?

Now I see the rx-SNR of the client, but how to see tx-SNR ?

Any news?

you can goto "wireless > registration table > "double click on the wlan you want to see" > and check the signal on the prompt up windows.

you can goto "wireless > registration table > "double click on the wlan you want to see" > and check the signal on the prompt up windows.

ok, but here i see only SNR on the AP side. How to see SNR on client side without connect every client and open his registration table?

It will only show the client signal if your clients are mikrotik devices.

Kindly regards

AP and client are Mikrotik devices.

On the AP I see:
Rx/Tx CCQ
Rx/Tx Signal Strength
Rx/Tx Data Rate
Rx Signal to Noise Ratio (SNR)
Rx Noise Floor

Why I can't see Tx SNR (or Tx Noise Floor)??

Like this?
Is possible?

Normis?