Hi, I would like to make a redundant network like the following diagram:


In this example I need to have k.o. all five center RBs to stop communication between left and right radio.

How can I configure my RB433AH to do this?
Thanks.

With that setup it looks like you would be best off running WDS with RSTP bridging or in mesh mode. There are some examples on the Wiki.

Hi, I would like to make a redundant network like the following diagram:


In this example I need to have k.o. all five center RBs to stop communication between left and right radio.

How can I configure my RB433AH to do this?
Thanks.

I've found these notes on wiki:

http://wiki.mikrotik.com/wiki/Mesh_wds

if them are the right ones.
So it's just to set the bridge to run in SRTP mode?


Step n°2: I have to make this connection to have a redundant, safe connection between 2 PCs, so I should use the same configuration? I think yes......or not?

And if I have a cable link with a redundant radio-link, is it still the same bridge configuration?

Sorry, I have problems with attachments; let's say my complete system would be this:


http://www.crs.inogs.it/telemetria/supersafe.TIF

Where my main connection is through optic fiber (in the schematic is a long ethernet cable), then I would place 4 radios.
So the link is if the fiber optic link is BROKEN and, at AT THE SAME TIME I have AT LEAST 3 radios broken on 4 available.
Is the RSTP mode correct or have I to do something more?
Thanks.

don't use TIF, use JPG or PNG for attachments in the forum

Ok, so that's my betwork:

Ok, let's take this:

http://wiki.mikrotik.com/wiki/Testwiki/ ... s_networks

Let's image in Figure 14.3 I have routers C and D connected also trough ethernet cable (so wireless + cable).
How can I setup ethernet port to work correctly?
Just set bridge in RSTP mode or anything else?
Thanks.