i wanna made a transparent bridge using two SXT but reults are horrible, can anyone tell me the trick to increase the throughput distance o link is approx 6 km.
thxs
here are the attachments
1. Your signal (-72/-75) is not that good. It should be-60 to -65.
2. You don't show us the SNR and CCQ.
3. Try enable HT Extention Channel --> below control
4. Enable nstreme (with framer policy=best fit and framer limit=3200) or NV2.
thxTry to use 40MHz channel width instead of 20mhz!
thanks normis.set both devices to Nv2 mode. Also try to align them better, to improve signal. What about line of sight and interference? Could try to change frequency, use Snooper or Spectrum analyzer features to see other frequencies that are used.
again: you are using a very old RouterOS version. upgrade to latestthanks normis.set both devices to Nv2 mode. Also try to align them better, to improve signal. What about line of sight and interference? Could try to change frequency, use Snooper or Spectrum analyzer features to see other frequencies that are used.
when i set both of these to NV2, the link between these is completely lost, and i cnat see any signal in registration TAB. i have tried various frequencies and line of site is perfect.
Regards
Oh sorry! I didn't know that the SXT did NOT support 40MHz channels, but from what i've seen the card should run 105mbit/s without a problem so 20mhz channels should be fine! And as everyone else says: Upgrade to latest ROS!thxTry to use 40MHz channel width instead of 20mhz!
but from where i can get 40 MHz enabled, i dont see this option in my SXT
ROS VERSION IS = 4.14