Page 1 of 1

Continuous Tx Spectrum Test for Certificaiton

Posted: Fri Jun 08, 2012 10:07 am
by Roy
https://www.youtube.com/watch?v=7GCJYAS ... ata_player

I'm testing Continuous Tx test for Certification.

For spectrum test, I set mode as "alignment only"
Please refer to attached youtube video.

Spectrum result is not clear pattern.
I used RB433GL + WLM200N5-23(compex)/DNMA-H5(UNEX)
let me know how setup for clear spectrum pattern.

Re: Continuous Tx Spectrum Test for Certificaiton

Posted: Fri Jun 08, 2012 11:56 am
by uldis
could you tell us what test you need - receive (so the wireless card is just listening and not transmitting) or transmit (so the wireless is constantly transmitting frames)?

Re: Continuous Tx Spectrum Test for Certificaiton

Posted: Fri Jun 08, 2012 1:25 pm
by Roy
I want to test Continuous Tx. Wanted result is clear pattern of Spectrum analyser.

Other manufacturer provide me "RF test firmare" and ART program for this test.

Re: Continuous Tx Spectrum Test for Certificaiton

Posted: Fri Jun 08, 2012 1:48 pm
by uldis
please contact support@mikrotik.com about this question

Re: Continuous Tx Spectrum Test for Certificaiton

Posted: Mon Jun 11, 2012 3:44 pm
by Montana
Is this possible with mikrotik? I have needed something simple like this in the past. What I have done was to set up two systems with 2 computers running iperf and a spectrum analyzer. It was a pain due to the number of parts. A simpler setup would be great.