Community discussions

MUM Europe 2020
 
WirelessRudy
Forum Guru
Forum Guru
Topic Author
Posts: 3089
Joined: Tue Aug 08, 2006 5:54 pm
Location: Spain

P2P radio chain both end same polarization?

Sun Jul 01, 2012 7:39 pm

I always make sure both ends of a H+V pol. link have same polarization connected to same chain.
i.e. CH0 to H, and CH1 to V. on both ends...
But is this really needed?
I am now in a situation I don't know how the other end is connected. Preparing a new end but don't know which pol should be connected to what chain?

So, does it has any importance at all?
(would save me a trip....)
Show your appreciation of this post by giving me Karma! Thanks.

Rudy R. Puister

WISP operator based on MT routerboard & ROS.
 
mgutz2
Frequent Visitor
Frequent Visitor
Posts: 97
Joined: Wed Jul 07, 2010 8:55 pm
Location: Nicaragua

Re: P2P radio chain both end same polarization?

Mon Jul 02, 2012 8:49 pm

when this occur always i have the gain no equal, one site can have -65 and the other -75 i loss 10db.
 
WirelessRudy
Forum Guru
Forum Guru
Topic Author
Posts: 3089
Joined: Tue Aug 08, 2006 5:54 pm
Location: Spain

Re: P2P radio chain both end same polarization?

Tue Jul 03, 2012 12:15 am

when this occur always i have the gain no equal, one site can have -65 and the other -75 i loss 10db.
That makes no sense. The signal emiting from each antenna (H or V), no matter if it comes from the CH0 or the CH1 is the same. That should not make a difference I would think.
Show your appreciation of this post by giving me Karma! Thanks.

Rudy R. Puister

WISP operator based on MT routerboard & ROS.

Who is online

Users browsing this forum: No registered users and 23 guests