Page 1 of 1

P2P radio chain both end same polarization?

Posted: Sun Jul 01, 2012 7:39 pm
by WirelessRudy
I always make sure both ends of a H+V pol. link have same polarization connected to same chain.
i.e. CH0 to H, and CH1 to V. on both ends...
But is this really needed?
I am now in a situation I don't know how the other end is connected. Preparing a new end but don't know which pol should be connected to what chain?

So, does it has any importance at all?
(would save me a trip....)

Re: P2P radio chain both end same polarization?

Posted: Mon Jul 02, 2012 8:49 pm
by mgutz2
when this occur always i have the gain no equal, one site can have -65 and the other -75 i loss 10db.

Re: P2P radio chain both end same polarization?

Posted: Tue Jul 03, 2012 12:15 am
by WirelessRudy
when this occur always i have the gain no equal, one site can have -65 and the other -75 i loss 10db.
That makes no sense. The signal emiting from each antenna (H or V), no matter if it comes from the CH0 or the CH1 is the same. That should not make a difference I would think.