Wed Sep 19, 2012 4:47 pm
The Wavion has settings to hide the ssid just as any other AP.
Be sure to also use 802.11 as the protocol.
Use RTS/CTS on the client also.
Your best to set the SSID manually.
When scanning, you may not see the AP at a very high signal level as the Wavion must establish the parameters for a beam, and with the wavions ability to NULL fill signals on a scan may or maynot be significant enough.
Simple preconfigure the client and aim in the general area until a connection has been established then fine tune for signal level and CCQ.