Hi,

i have a simple setup of 5 RB751, one is configured as hotspot-gw, the others are simple wds-slaves. In the current lab-setup all devices can see each other by wifi.

The gateway has "Mesh Portal" configured. All other settings are default settings and i use dynamic-mesh in the wifi settings.

Now when one accesspoint is getting lost (i.e. rebooted) everything is ok but when it comes back (topology change?) i loose the whole wds mesh for about 45 seconds and i can not reach any of the other (still connected) accesspoints.

I didnt find any good howto or anything like that, that could help me with that issue

Any ideas?

Regards,
Joerg

Mesh is still broken and does not have the wds loop fix that were introduced to bridging in the 5.18 fix - or so I was told when I questioned this with support. They 'may' get around to fixing it.

Your simply getting a L2 loop which floods the network until it finally sorts itself out.

is there any workaround? this is REALLY annoying issue because its causing a lot of outages