Community discussions

 
nizami
just joined
Topic Author
Posts: 8
Joined: Sun Mar 17, 2013 9:08 pm

Can I run same frequency on same RouterBoard.

Sun Mar 17, 2013 9:17 pm

I want to know, using RB433AH routerboard with 2 r52h wireless card. Is it possible to use same frequency "2484" on 2.4Ghz with same band for point to multipoint network through sector antenna at same location.
 
bmv
just joined
Posts: 17
Joined: Sun Aug 15, 2010 1:15 pm

Re: Can I run same frequency on same RouterBoard.

Sun Mar 17, 2013 10:53 pm

I want to know, using RB433AH routerboard with 2 r52h wireless card. Is it possible to use same frequency "2484" on 2.4Ghz with same band for point to multipoint network through sector antenna at same location.
No.
You can, but the performance will be rubbish!
They will interfere with each other.
You need to select non-overlapping frequencies for each radio.
 
nizami
just joined
Topic Author
Posts: 8
Joined: Sun Mar 17, 2013 9:08 pm

my P throughput goes down for limited clients why?

Tue Mar 19, 2013 6:09 pm

Some of my clients "P throughput" drop down and up every second when they are on and sending or recieving traffic from my network and they are not getting full bandwidth and their "ping ms" goes very high. I don't know the exact issue. Please help me.
 
0ldman
Forum Guru
Forum Guru
Posts: 1446
Joined: Thu Jul 27, 2006 5:01 am

Re: Can I run same frequency on same RouterBoard.

Wed Mar 20, 2013 7:33 am

If you have two cards in the same band on the same board you need to lower the tx to below 20dBm, lower than that is better.

At full power an R52H can see another R52H on the same band at -25dB, which even if the channels are far apart (5260 to 5825) they still cause significant problems.

Drop the tx power as low as you can make your links reliable, or preferred, put each radio on the same band in a different metal enclosure as far apart as possible.
 
hngtron
just joined
Posts: 5
Joined: Sat Mar 23, 2013 9:46 am

Re: Can I run same frequency on same RouterBoard.

Sat Mar 23, 2013 10:32 am

I would also suggest enabling hw-protection on both cards if you must use the same frequency on both. try cts-to-self first, and if you still have problems try rts-cts. also enable adaptive noise immunity

Who is online

Users browsing this forum: No registered users and 42 guests