Is it possbible to use a mesh network in my diagram?
And how to configure this?
I have a wireless link (point2point) between 2 Sextands over 700 meters.
On both sides of the link is a Mikortik device wired connectd to the Sextant.
at side one I have an RB951G wired coonected and at side 2 I have a Ominitik wired connected.
I want to create 2 mesh networks if it is possible.
At side 1 I want mesh the 2 SXT's with the RB951G
At side 2 I want mesh the 2 SXT's with the omnitik.
Is this possible? I want this because I can't connect this SXT devices with a wire.