today received couple of 912 outdoors

here the results at 12kms.

tomorrow ill post 65kms with 34db rocket dish.

now overclocked

Can i ask was the bandwidth test from RB912UAG-5HPnD to RB912UAG-5HPnD or a device before and beyond the RB912UAG-5HPnD pair?

Can i ask was the bandwidth test from RB912UAG-5HPnD to RB912UAG-5HPnD or a device before and beyond the RB912UAG-5HPnD pair?

Look at the picture. This is another speedtester who measures cpu instead of bandwidth.
I love my customers which complain that speed is to low. If I ask back they dont know if they measured Mbit or Mbyte/s

Test from 912 to 912,, no other equipment between them.

You should test as follows: connect on both sides of the link a PC to the Routerboard and run an Iperf session between them.
If you use btest on the Routerboard itself you are, in fact, testing its CPU and not the link.
Doing a TCP bandwith test on the router itself is very demanding for most routers. Running a bandwidth test THROUGH the router is far less CPU intensive and therefore a better test.

Test from 912 to 912,, no other equipment between them.

As mentioned the best way to bandwidth test is,

Router A (connected to) 912 (PTP) 912 (connected to) Router B

Bandwidth test from RouterA to RouterB and not 912 to 912

today received couple of 912 outdoors

here the results at 12kms.

tomorrow ill post 65kms with 34db rocket dish.

Where is that link?

(se for Brasileiro como imagino)

Aonde foi feito este enlace amigo ?