In station mode you cannot bridge the interfaces. In WDS Station mode you can bridge the interfaces and also connect to an AP in WDS mode. In dynamic WDS, WDS interfaces are generated automatically, where as in static WDS you have to manually create the WDS interface. To connect two APs in WDS mode you should set the same SSID, frequency and dynamic WDS. You should also select bridge1 in the WDS tab. You should set the IP address on the bridge not on the WDS interface as the WDS interface is dynamic. The IP address on the two AP cannot be the same. Hope this helps!
well, i think thaty is fir the wirelesslan interface not for the wds interface. i idid that for the wireless lan interface. the main problem is that i made a wds connection with a linksys. i can see that the linksys eith ddwrt firmware establishs a connection with my mikrotik because it appears in the registration table but i cannt get to ping it or transfer any kind of data. i also noticed that in the registration table, the ip addresses of clients behind the linksys appears in the last ip address field but i still cant ping in any direction