Community discussions

MUM Europe 2020
 
pgb
just joined
Topic Author
Posts: 4
Joined: Mon Apr 04, 2005 7:07 pm

AP isolation

Thu Jun 29, 2006 4:22 pm

Is it possible to configure AP isolation or Wireless isolation?, so that mi wireless clients cannot "see" each other.

RouterBoard 532 with a Prism 200mw wireless card.

Thanks!.
 
cmit
Forum Guru
Forum Guru
Posts: 1552
Joined: Fri May 28, 2004 12:49 pm
Location: Germany

Thu Jun 29, 2006 5:19 pm

Set "default-forwarding=no" on your wireless interface...

Best regards,
Christian Meis
 
pgb
just joined
Topic Author
Posts: 4
Joined: Mon Apr 04, 2005 7:07 pm

Mon Jul 03, 2006 4:02 pm

Thanks a lot. That did it!.
 
matthias
Frequent Visitor
Frequent Visitor
Posts: 54
Joined: Tue Jul 11, 2006 8:41 am

Fri Jul 21, 2006 11:42 am

but i think this works only for one wireless card, right?

how to do, if you have two cards on an AP ??
Is it also possible to isolate them?
Or with two AP in one network?
 
User avatar
djape
Member
Member
Posts: 469
Joined: Sat Nov 06, 2004 7:54 pm
Location: Serbia

Fri Jul 21, 2006 12:37 pm

It is possible with basic knowledge of networking...everything else is in manual...
I drink like a pirate and smoke like a hippie...
 
User avatar
samsoft08
Long time Member
Long time Member
Posts: 617
Joined: Sat Nov 26, 2005 10:52 pm

Sun Aug 06, 2006 2:45 pm

hello

i'm using a bridge of 2 D-link 2100 AP , first connected to MT , second is connected to a switch ,an outdoor AP with omni connected to the switch, about 7 users are connected to the switch by wires , this is my setup ..

1- do the 2100AP is capable to handle this trafick ? total is 30+ users..
2- is it ok with the switch setup ? 2100AP-switch-AP-25 wirless users and the same switch- 7 lan users ??

please need some help..

Who is online

Users browsing this forum: Bing [Bot], bpwl, lucasimo88 and 30 guests