I'm trying to setup an additional (SSID) AP for a site, accross four routerboards.
On each RB912 device, the wlan1 interface is bridged with the ether1 port, and an IP address assigned to the bridge
The wireless interface is set to apbridge
I then added a Virtual AP to each device, named wlan2, and ensured that wlan1 is it's master port
and assigned an IP address belonging to a different subnet than that of the bridge
The central, default gateway, device, an RB2011 2HnD, is also configured with the wlan2 Virtual AP
Now I'm not sure what the next step is; do I need to create a vlan linking the APs to the RB2011
to cater for the second IP subnet ?