Attached is a chart that I have for the 1 Minute CPU Usage of a Cisco SG300 switch. The data seems accurate, however why is the Y axis on the chart in milliseconds instead of percent utilization. Is there any way to fix this?

Thanks

apiel1,

May you show us a Data Source of this chart?

Thank you!

The unit for your probe could just have ms in the field or like the previous poster mentions post your data source.

Below is the probe i use to capture this data

Thanks

apiel1,

What version of the Dude do you use?

May you try to create a "Data Source" manually where you can specify % under Unit?

Thank you!

I am using v6.40 of the dude

apiel1,

May you try to create a Data Source manually like it is described in the forum post, "Create a chart" section?

Thank you!