Community discussions

MUM Europe 2020
 
LordNikkon
just joined
Topic Author
Posts: 1
Joined: Thu Jan 23, 2020 1:12 pm

Creating ping probe with source - IPsec monitoring

Fri Jan 24, 2020 9:13 pm

Hello,

I'm new in Dude. Most thing i created with smaller or bigger problem.

I need to create probe which will ping between remote routers and show ping time or simply UP status as a lable on the line between routers. Below i create simple picture.

Host A is router with dude server. I can create without problems ping probe between Host A --> B and host A --> C.

Host B and C see each other and using ping tool i can ping B to C and C to B.

I need somehow to put source (?) in this probe but don't know how. I need it to monitor raw IPSec tunnels between remote locations. I was using l2tp which was great because was showing as interface on each remote router but performance impact was huge so i moved back to IPSec but i lost easy ability to monitoring remote tunnels (others than this on Dude).

Please help.
You do not have the required permissions to view the files attached to this post.
 
excession
newbie
Posts: 35
Joined: Mon May 11, 2015 8:16 pm

Re: Creating ping probe with source - IPsec monitoring

Wed Feb 12, 2020 8:57 pm

You can run a ROS cmd and use it's output in a device label:
[ros_command(":put [/ip ipsec active-peers print]")]
Or you could add a device from the other side of the link to your map and use that to indicate the status of the tunnel.
Or a combination of the two with the ros cmd output displayed on the link appearance.

Who is online

Users browsing this forum: No registered users and 12 guests